the ZP-2DM, the midrange control is a knob on the instrument’s face. Turning
the control clockwise boosts the mids. Turning the control counterclockwise
cuts the mids. A detent, or “click,” in the center of the control is the “flat” posi-
tion, zero boost or cut.
Treble control. 15dB boost or cut of treble at a center frequency of 3kHz.
Turning the control clockwise boosts the treble. Turning the control counter-
clockwise cuts the treble. The detent, or “click,” in the center of the control is
the “flat” position, zero boost or cut.
1514
ZP-2D & ZP-2DM
MODELS: Sonus Custom, Legacy Elite, Legacy Elite Special
Description: Class A design with studio-grade compo-
nents on a printed circuit board
Function: Active master volume, pickup blend. Bass,
treble and internal midrange boost/cut
Specifications: Output level +16dBm. S/N ratio 100dB
Power requirements: One 9-volt battery
Battery life expectancy: 200 hours continuous use
About the system
Volume control. Unlike passive volume controls, which decrease the volume
by shorting some of the signal to ground, causing degradation in tone, the
active volume control on the ZP2 allows the volume to be set to any level with-
out overall loss of highs or tonal change. Play a note, let it ring while slowly
turning this control up and down, and you’ll hear no change in tone.
Pickup blend control. Buffered inputs provide exacting control over blending
the neck and bridge pickups. This feature allows even the most subtle blend,
for a greater variety of tone. Turning the control clockwise brings in the bridge
pickup. Turning the control counterclockwise brings in the neck pickup. The
detent, or “click,” in the center of the control is the point where both pickups are
on equally.
Bass control. 15dB boost or cut of bass at a center frequency of 30 Hz.
Turning the control clockwise boosts the bass. Turning the control counter-
clockwise cuts the bass. The detent, or “click,” in the center of the control is the
“flat” position, zero boost or cut.
Midrange control. 15dB boost or cut of midrange at a center frequency of
330 Hz. On basses equipped with the ZP-2D, the midrange control is an inter-
nal trimmer on the circuit board. Turning the control clockwise boosts the mids.
Turning the control counterclockwise cuts the mids. The midpoint in the con-
trol’s sweep is the “flat” position, zero boost or cut. (You will need to remove
the control cavity’s cover plate to adjust this control.) On basses equipped with
Bass
Master volume
Midrange
(ZP-2DM only)
Pickup blend
Treble
Midrange (ZP-2D only)
(25 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals