Zon Sonus519 Operations Instructions download pdf (Page 6)

GUITARS

1110

Mosaic

This model has one dual-action

truss rod, which allows the

neck to be adjusted in either

direction. Therefore, it is possi-

ble to compensate for under-

bow or overbow.

Making adjustments. Remove

the cover plate behind the

string nut on your instrument.

Using the 4mm hex wrench

supplied with your instrument,

turn the adjusting nut clockwise

to decrease the amount of

relief and straighten the neck,

or counterclockwise to

increase the amount of relief,

giving the neck underbow.

Mosaic Pro

This model has a single rod

for neck adjustment. Dual

graphite bars embedded in

this neck add extra stiffness

and assist the truss rod in

providing a balanced adjust-

ment.

Making adjustments. Locate

the adjustment nut at the heel

of the neck. Using the 9/64"

hex wrench supplied with your

instrument, turn the adjusting

nut clockwise to decrease the

amount of relief and straight-

en the neck, or counterclock-

wise to increase the amount

of relief giving the neck under-

bow.

Electronics

The electronics on your Zon bass are made to provide you with versatil-

ity and optimal tonal shaping. Each “package” is designed to work in

conjunction with and complement the other components of the instru-

ment so that the “sum of all the parts” will culminate in the distinctive

voice prescribed for that particular model.

General

All of our active electronics use the highest-quality components for low-

noise, long-term use and reliability. Power consumption varies with each

circuit, depending on the complexity of its functions. Low power

reserves are indicated by a loss of output and an increase in noise or

distortion. To remedy this situation, change the battery (or batteries).

Before changing the batteries, be sure the cable is not plugged into the

output jack of the bass. Remove the backplate screws and cover, and

then unclip the battery from the harness. Be careful not to yank the har-

ness, as this action may cause the wires to break from their connec-

tions.

Transfer the foam jacket (which helps prevent the metal case of the bat-

tery from shorting the components) from the old battery onto the new

one and attach the harness connector in place. Install the backplate and

connect the guitar cable to test.

Note: To prolong battery life, unplug your instrument when you are not

playing. If your bass requires two batteries, always change both of them

at the same time.

Warning: Replace the battery with a good-quality 9-volt alkaline. Do not

use rechargeable batteries.

Fig. 9. Turn the Mosaic Pro’s single

adjustment nut to set the amount of

relief and straightness.

Fig. 8. Turn the single hex adjustment

nut on the Mosaic small amounts to

adjust relief and straightness.

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comments to this Manuals

No comments

Zon Sonus519 Operations Instructions Page 6

Comments to this Manuals

Related products and manuals for Guitars Zon Sonus519