12
4. Waveform display for currently - This view shows the visual waveform of the entire track,
allows for viewing the remaining duration of the audio, as well as what has already been
played. When highlighted in blue or red (Using the default skins), that area of the waveform
indicates what has been played and the current position of the audio. The remaining grey area
of the waveform shows the length of the audio remaining. Inside the waveform itself, the lighter
part indicates the presence of beats whereas the darker part indicates the presence of vocals
5. Effects
Effects Selection Drop-down arrow - Select which effect to apply.
Effects Selection Drop-down window - When clicked this will apply the effect selected.
Parameter 1 & 2 knobs - These two knobs adjust parameters of the effect selected in the drop-
down window, although not all effects require or make use of these knobs.
6. Loop Sampler -
Sample Selection Drop-down arrow - Choose which sample to use. There are 12 slots which
are available to record, load and play samples.
Sample Selection window - When clicked this will play the sample listed in the selection
window.
VOL - Controls the level of gain applied to the loop sample.
REC button - When initiated, this function records the loop to the sample slot selected. If no
loop is currently set on this deck, a 4 bar loop will be recorded by default.
Sampler Loop controls – used to half or double the samples length.
7. Loop Set /Control
Loop In/Out - A loop is any area of a track that repeats seamlessly. Press ―Loop In‖ at the point
where the loop is to start. Press ―Loop Out‖ when the desired point to mark the end point of the
loop. The audio between the two points will begin to loop continuously. To release the loop and
continue play of the track press ―Loop Out‖ again and the audio will continue from the end point
of the loop. To set a new loop, just press ―Loop In‖ again while the loop is disengaged, and then
press ―Loop Out‖ to begin the new loop.
Shift Knob - Adjusts the loop length by half length or double length increments.
Smart Lock button - Allows the loop buttons to work together to create loops synchronized to
BPM.
Loop Length - This indicates the length of the loop according to beat measures. Increase or
decrease the length of the loop from 1/4 to 16 measures.
8. Virtual Turntable – can be used with the mouse to scratch, back cue, and pause a playing
track. The virtual table also has a position marker on it for visualizing a scratch position.
Around the outer edge of the virtual table is a position ring that gives a reference to percentage
of a tracks completion.
(208 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals